Use this guide to learn all about loading and using a caulking gun like an expert. Prep the Caulk Canister.
The size of your gap determines how you should cut the tip.
How to use a caulk gun for the first time. If not a utility knife will do the trick Image 2. Next cut off the tip of the tube and position the nozzle. Pull it as far as it will go towards the rear of the gun.
If you have an older ratcheted rod gun then youll have to flip the rod 180 degrees before it starts moving. Open the tube of caulk by snipping off the tip at a 45-degree angle or use the cartridges built-in snipper if it has one. Put the tube of caulk into the caulk gun and use the trigger to pump a thin bead of caulk onto the surface where its needed.
If your gun is a smooth rod style then pull back on the push rod. Facedown the tip of the tube to level it. Load the Tube into the Barrel of the Caulk Gun.
In cases where the caulk gun has a pointed rod and blade for cutting the tip on the frame Use them before returning the tube into the frame of the caulk gun. Position the caulking gun at a 45-degree angle. Because of the way the sealant gun is built you simply place the caulk into the gun and using the hand trigger to apply pressure the device delivers a stream of sealant to the designated area.
There are two types of caulk gun rods the ratchet rod and the smooth rod. How to Use a Caulk Gun Step 1. Place caulk into caulk gun.
For every serious DIY enthusiast learning how to use a caulk gun for the first time is a must. A caulk gun is an item that takes the hard work out of caulking. Puncture the tubes seal with a small nail or similar item.
Then secure the tube by pushing the metal rod back into the frame. Remember you can always cut a larger hole but cutting a larger hole than your gap requires will. If you have a spout cutter on your gun simply stick the tip in and cut Image 1.
Its a precondition to get the sealing like a PRO. To use a caulking gun press the release trigger at the back of the gun pull back the metal rod and insert the caulk tube into the frame. Press the material firmly but carefully toward the surface area.
Its time to load a tube of caulk into your gun. If you are doing a job that requires precision and a really thin line cut the very tip off at a 45-degree angle. First insert the sharp end of the tube behind the caulk gun until it reaches the back of the gun.
Before you load the caulk into the gun you first need to cut the tip and break the seal. Handling the gun like a PRO will ensure exactly how much caulk is released and where you want it to come out. Applying caulk this way is called laying a bead Use that next time youre having a similar conversation if you want to sound like a professional.
First you will need to snip the tip off the nozzle on your canister of caulk.